First, open the rear of the flashlight, take out the battery, and tear off the battery insulation plastic film.
Switch function: S1 click, weak light, medium light, strong light, S1 long press infinite light change.
S2 click super bright, double-click pop, and long press the switch to turn on SOS.
Discharge indication: Four indicator lights
Charging indication: Four indicator lights are beating, and it is full when not moving at all.
XHP series product precautions
About XHP Series Flashlights
1, XHP 50/70/90/99/110/120/160/360 series of products have high basic brightness, and the heat is also more powerful than the ordinary T6 and L2 products.
- Although the segment current setting is made, its heat and heat dissipation are much higher than the requirements of ordinary products.
- Because the brightness is high, the current required to drive is large. Therefore, the capacity requirement of the battery is high. It is generally not recommended to use a battery of 1500 mAh or less.
2, For the choice of battery, it is recommended to use a tipped 18650/26650 lithium battery of 1500 mAh or more, (according to the battery requirements of the product), the battery performance is good to truly reflect the advantages of the XHP 50/70/90/99/110/120/160 series of product, otherwise it will be easy to use for a while. There is no electricity, or the product cannot start. 3. Using the product
a . First make sure that the battery is fully charged.
- The correct positive and negative poles are installed, check whether the joints are tightened, then press the switch to start.
- To save energy, it is recommended to use low-grade lighting, generally enough. Cope with outdoor lighting. If it is in the summer and the weather is hot, the heating problem of the product will be more obvious than in the winter. lf the fever is very hot, you can use it in low gear or turn off the power, and then continue to use the product after it has cooled down.
- For flashlights with low-power reminder function, when the display power is insufficient, it needs to be charged in time, otherwise it will cause over-discharge, which may cause the battery to not be charged. For products that do not have a low battery reminder, when the power light details become weaker, it is also necessary to charge in time, and the battery cannot be exhausted.
Second, the method of use
- Check the battery: Make sure the battery has electricity, tear off the insulation protection, and install the flashlight in the correct direction. {Positive inward (on the side of the lamp), negative in the outside(tail)
- When using the flashlight, according to the voltage and battery requirements of the flashlight, do not use it indiscriminately to prevent the circuit board from being burned out. Do not use the batteries of different models and voltages at the same time. The old and new batteries cannot be mixed.
- In use, when the brightness of the flashlight changes significantly, turn off the flashlight to prevent the battery from being over-discharged and timely charged; pay attention to the battery's waterproof, moisture-proof, anti-drop, etc., according to the charging speed of the charger when charging, After the indicator light changes, remove it in time, do not overcharge; 4. For batteries that are not used for a long time, the battery should be fully charged and stored, and then charged and discharged once every three months to avoid chemical corrosion; 5. The inner wall of the lamp cup is kept clean. Never wipe it with your hand or a hard object.
Remove the fingerprint on the lens and wipe it gently with a cotton swab and lens cleaner.
- Do not touch the flashlight with sunlight, water, chemicals and corrosive gases for a long time to avoid damage to the flashlight.
